The Studio Linear Amplifier will be installed in one of the laptet’s. This will be just a little bit different from the other laptet unit’s.
Basic Controls
- Front Panel:
- Power Switch
- Channel Attenuators
- Signal LED indicator
- clip LED indicator
- Protect LED indicator
- Rear Panel
- AMP Mode Switch
- Ground lift Switch
Tips:
- Refer to the manual attached to this page titled: sla1.pdf for the proper orientation of the wires for each setting. (stereo, bridge, etc.)
- Keep the sound level all the way down until you begin to play the sound of your choice, then slowly move the volume up, it can get loud quickly.
- Be sure to check with the out put cable which part is postive and negative, if you are not sure use a multi-meter and the end which is connected to the tip of the 1/4 inch will be positive.
- When switching from channel 1,2, or stereo from bridge use the black and red screw tops in the back, place the output cable into the holes which will be revealed after unscrewing the red and top caps just a little bit. Once the end of the cable fits in the hole screw the caps back on.